A water-repellent treatment works by allowing fluoropolymers or silicones to penetrate deep into the fibres of the fabric, so that each individual fibre is coated with a water-repellent layer. This process is called deep impregnation and ensures that water droplets do not soak into the material but roll off it. In the sections below, we answer the most frequently asked questions about exactly how this works and when you need to re-waterproof.
What happens to the fibres in untreated tent fabric?
Without waterproofing, the fibres of tent fabric are completely open and porous. Rainwater, dirt and mould spores can then penetrate the material directly. The fabric becomes heavy, loses its insulating properties and dries slowly, which greatly increases the risk of mould growth.
Canvas, polyester and nylon are naturally somewhat water-resistant, but this is not sufficient for prolonged exposure to rain or damp. Without a protective treatment, the fibres become saturated more quickly. A wet tent fabric that remains damp for a long time is an ideal environment for green deposits and mould. Furthermore, moisture damages the structure of the fibres themselves, causing the material to become more brittle over time and more prone to tearing or fraying.
How does a wood preservative penetrate the fibres?
An impregnating agent penetrates deep into the fibres because the active ingredients – usually fluoropolymers or silicones in a liquid base – are absorbed into the fabric via capillary action. Each individual fibre is coated with a microscopically thin, water-repellent layer which does not seal the pores of the material, but increases the surface tension of the fabric.
This process works best when the fabric is slightly damp or clean, as the fibres are more open at that stage. The impregnating agent is applied as a spray or liquid and is then absorbed. After drying or activation by heat – for example, from the sun or a hot-air dryer – the protective layer polymerises and bonds firmly to the fibres. The result is a treated fabric from which water droplets roll off the surface in beads, a phenomenon known as lotus effect.
Ready for your next adventure?
Discover Rokimi’s professional cleaning and protection products and keep your tent fabric, awnings, boat covers and other outdoor equipment looking good for longer.
✓ Professional formula
✓ Specialist in cleaning & protection
✓ Certified quality
What is the difference between a surface coating and deep impregnation?
A surface coating applies a protective layer to the fabric without treating the fibres themselves, whilst deep impregnation allows the active ingredients to penetrate the fibres themselves. This distinction is crucial to the durability and effectiveness of the protection.
A surface coating wears out more quickly because it is directly exposed to friction, UV radiation and the elements. Once that layer is damaged, the material underneath offers virtually no resistance. Deep impregnation is more robust: even if the surface is slightly damaged, the fibres themselves are still treated and water-repellent. For tent fabric, which is regularly pitched, taken down, stored and exposed to sun and rain, deep impregnation is therefore the most effective and long-lasting choice.
Why does tent fabric lose its water-repellent properties after cleaning?
Tent fabric loses its water-repellent properties after cleaning because cleaning products partially break down the waterproofing layer or cause it to detach from the fibres. Soap and other cleaning products contain substances that reduce surface tension, which is exactly the opposite of what an impregnating agent does.
Mechanical action, such as brushing or scrubbing, also damages the microscopically thin protective layer on the fibres. The more thorough the cleaning, the more of the original impregnation is lost. This does not mean that you should not clean your tent thoroughly – quite the contrary. It does mean that cleaning and re-impregnation should always be carried out in combination should be taken into account. A clean tent without a fresh waterproofing treatment is more vulnerable than an uncleaned tent with an intact protective coating.
When is re-impregnation necessary?
Re-impregnation is necessary when water no longer beads up and rolls off the fabric, but soaks into the material and forms stains or wet patches. This is the clearest sign that the water-repellent effect has worn off. In addition, re-impregnation is always recommended following a thorough clean.
Good times to reapply the waterproofing agent are:
- At the start of the camping season, after winter storage
- Immediately after cleaning the fabric, whether using a mild shampoo or a powerful cleaner
- After an action-packed weekend away, whether it rained or the sun shone
- When the fabric visibly absorbs water rather than repelling it
- After several years of use, even if there is no visible damage
The frequency depends on how intensively you camp and under what conditions. A tent that is used for several weeks every year and regularly gets wet will need to be re-treated more often than one that is used only occasionally.
How can you tell if the wood preservative has been properly absorbed?
You can tell that the waterproofing agent has been properly absorbed when water droplets remain visible on the surface and roll off without being absorbed into the material. This ‘lotus effect’ is the most reliable indicator that the treatment has been successful and that the fibres are well coated.
A simple test is to sprinkle a small amount of water onto the fabric once it has dried. If the water rolls off immediately without leaving a wet patch, the impregnation is effective. If the water is absorbed or forms a flat puddle on the surface, the treatment is insufficient or the fabric needs to be treated again. Also check for an even, matt sheen across the entire surface after drying: uneven patches may indicate areas where the product has not been applied or absorbed properly.
Heat helps to activate the waterproofing agent and improve its adhesion. After treatment, it is best to leave the fabric to dry in the sun or use a hot-air dryer on a low setting to aid the process.
How Rokimi helps with waterproofing tent fabric
Here at Rokimi, we have developed our product range specifically for campers who want to protect their tent fabric effectively, without any hassle or uncertainty about which product to choose. Whether you want to waterproof canvas, polyester or nylon fabric, our products are ready to use straight away and do not need to be diluted.
- Hood & Tent Shampoo removes green deposits and light soiling without damaging the fibres, so that the fabric is ready for treatment
- Heavy Duty Cleaner tackles stubborn stains, mould and ingrained dirt that have built up after winter storage
- Hood & Tent Protection is the most effective impregnating agent of its kind and penetrates deep into the fibres to provide long-lasting water-repellent protection
Together, these three products form a complete care cycle: cleaning, deep cleaning where necessary, and then waterproofing. This way, you can be sure your tent will start the new season in top condition. View our full product range or read more about the applications for your specific material. Want to get started straight away? Go to rokimi.com and find out which product best suits your situation.
Frequently Asked Questions
Can I use any waterproofing product on all types of tent fabric?
Niet elk impregneermiddel is geschikt voor elk materiaal. Canvas, polyester en nylon hebben elk een andere vezelstructuur en absorptiegraad, waardoor de keuze van het juiste middel belangrijk is. Controleer altijd of het product expliciet geschikt is voor jouw type doek. Rokimi’s Hood & Tent Protection is bijvoorbeeld speciaal geformuleerd om op alle gangbare tentmaterialen effectief te zijn.
What’s the best way to apply a wood preservative: spray or liquid?
Both methods can be effective, but it depends on the situation. A spray is handy for targeted treatment of smaller areas or hard-to-reach seams and corners. A liquid product applied with a sponge or cloth often gives a more even result on larger tent surfaces and ensures deeper impregnation. In both cases, make sure the fabric is clean and slightly damp before you start.
What if I waterproof my tent but the water still doesn’t run off properly?
This is usually a sign that the fabric was not properly cleaned before treatment, or that the waterproofing agent has not been sufficiently activated. Dirt, grease or residues of cleaning products can prevent the active ingredients from penetrating the fibres properly. Clean the fabric thoroughly again, leave it to dry, and then reapply the impregnating agent. Next, activate the treatment using heat, for example by leaving the fabric to dry in the sun or using a hot-air dryer on a low setting.
Is it safe to waterproof a tent whilst it is pitched?
Yes, that’s actually recommended. By treating the tent whilst it’s pitched, the fabric is stretched taut, ensuring the waterproofing agent is distributed more evenly and preventing any creases or missed areas. Do ensure there is good ventilation if you’re using a spray product. Allow the tent to dry completely after treatment before packing it away to prevent mould from forming during storage.
How should I store my tent after waterproofing it to ensure it remains protected for as long as possible?
Always store your tent dry and clean, preferably in a well-ventilated room at room temperature. Storing it whilst damp is the quickest way to encourage mould and green deposits to form, even if the tent has been waterproofed. Avoid storing it in sealed plastic bags or damp cellars. A loose storage bag made of breathable material is ideal for keeping the fibres and the waterproofing layer in good condition until the next season.
Can I waterproof a tent that already has mould patches?
Waterproofing a tent that has active mould is ineffective and even inadvisable. The mould spores will remain trapped in the fabric and continue to damage the fibres, whilst the waterproofing agent cannot adhere properly to soiled fabric. First treat the mould with a suitable cleaner such as Heavy Duty Cleaner, allow the fabric to dry completely, and only then apply the waterproofing treatment. This gives the waterproofing agent a clean surface to work on.
How often should I waterproof my tent if I only go camping a few times a year?
If you only use your tent occasionally, in most cases it is sufficient to waterproof it once a season, preferably at the start of the camping season after winter storage. Always carry out a quick water test before setting off: spray a little water onto the fabric and check whether it still beads up. This way, you can be sure whether a re-treatment is needed, even if the tent has been used very little.
Everything you need for a clean and protected outdoor lifestyle.
Discover Rokimi’s range of professional cleaning and protection products.
VIEW ALL PRODUCTS →
